Got a lot of work done on the gauge tonight!
I'm wiped.
Opened the garage and it was still raining like crazy.
This is a good winter project.
First off I ran the wires in the harness for the shifter switches!
Also sealed off the connector with shrink tubing.
Then put a piece of shrink tube on the gauge
They connect and seat nicely
All powers up good still
If you look closely you can see a twisted wire running near my harness. That's the wires heading down to the shifter switches.
All I have left to do is connect these two wires to the switches. Then a wire from both switches to the frame as a ground. Then program the gauge!
Dayum I can't wait to have this thing done and working!
The brains of the outfit
finally my window is back in and the connections have been tested with everything back installed.
Extremely close to having this finished now. I knocked out a ton of work on it tonight.
I'd say it's about 90% done, unless of course I bump in to some unforeseen problems.