Since i got the swing arm all wrapped up i was able to futz with the shock and linkage. Just started working with a few of the pieces and trimming some things and making some junk mock bits out of polypropylene to check everything before i start making the real pieces. Need to fab up these brackets to secure the knuckle to the frame and dog bones. Shouldn't be too difficult but want to make sure i get it just right for geometry of the bike.
n250 rear shock and linkage knuckle FTW!!!
Had to alter the linkage knuckle a bit and cut off some of the width where the linkage will connect to the bike frame. I still need to clean it up a bit and even out the sides.
And a picture of some new to me parts i got in. Aprilia rs250 rear brake system and mounting bracket
__________________________________________________
I love the smell of burning pre-mix in the morning
I don't think I'm a lot dumber than you thought that I think that I thought I was once.