ninjette.org - View Single Post - 2007 Ninja 250 dies and wont start when warm

Hewes · September 19th, 2018, 11:14 AM

Thanks for the replies everyone. I'll check the ignition coil today.

I set the mixture screws to 2.5 turns out on the carb, I don't think its carb or airbox related since I went through these.

The PO replaced the gas filler with an okay quality aftermarket one so I'll check that again. The gas was good quality, I added 2 fresh gallons and 2 oz of seafoam to it and the floats have been drained several times.

I added a new inline fuel filter which I think may be too restrictive, it's meant for a tractor so maybe I'll look into swapping that back. If it's the ignition coil I may replace it.

September 19th, 2018, 11:14 AM	#7
Hewes ninjette.org newbie Name: Jacob Location: Raleigh Join Date: Sep 2018 Motorcycle(s): 2007 Ninja 250R Posts: 8	Thanks for the replies everyone. I'll check the ignition coil today. I set the mixture screws to 2.5 turns out on the carb, I don't think its carb or airbox related since I went through these. The PO replaced the gas filler with an okay quality aftermarket one so I'll check that again. The gas was good quality, I added 2 fresh gallons and 2 oz of seafoam to it and the floats have been drained several times. I added a new inline fuel filter which I think may be too restrictive, it's meant for a tractor so maybe I'll look into swapping that back. If it's the ignition coil I may replace it.