October 22nd, 2018, 02:58 PM
|
#80
|
ninjette.org certified postwhore
Name: Bill
Location: Port Huron, Michigan
Join Date: Mar 2017
Motorcycle(s): 2007 Kawasaki 250 Ninja, 1982 Honda Ascot FT500
Posts: A lot.
|
Quote:
Originally Posted by GreasedLissik
Good morning everyone, so I was able to install the 300 motor in the 250, I did use the 300 front mount bracket, the coil o plugs, stock exhaust, stator and magneto. I did start it up but i only did so twice, it seem that i have to check valve clearance and shim them, because there is a ticking noise. I did extend about 5 wires to make this work
And my biggest problem is that clutch needs to be held down to start the bike(which has never happened before) and when i go to release the clutch the bike died, i have today off and will check to see if my sensor is working after i shim the valves
|
Make sure your side stand is retracted when you release the clutch lever.
Bill
__________________________________________________
Insanity: doing the same thing over and over again expecting different results each time.
|
|
|