Good morning!
I hope that everyone is doing well!
I have a 2008 that previous owner had cut rear frame off. I am trying to do a mock up so that I can fabricate a new one and get the bike back to original.
Any suggestions or ideas on how to go about doing this would be much appreciated. I also have no clue how to calculate the exact position of the 2 cross brackets that the passenger seat snaps into.
I will try to attach photos.
Thanks in advance!
571C1107-40E7-4E84-B3FE-DD772809AAB0.jpg
B9CF8075-641A-4910-BE4D-FF9ADF0DD0CB.jpg