|
Not sure about some of the smaller screws, but I'd think the kit should have the right type.
Many years back, the case screws were "phillips" and the only way to get them out was with the supplied tools.
We used to replace them with allens most of the time though.
I do remember drilling the heads out on a few, pulling the cases, using vise grips on the studs and then installing allen bolts.
It's probably been twenty years since they used phillips on the case bolts.
But it might pay off to check the tool kit.
I do agreed, if you are going to do much work on bikes, buy the right tools.
|