Quote:
Originally Posted by ninjabadger
Looks very interesting.
From the pics, am I correct that the the installation of these sliders flexes the rear edge of the lower fairing out about half an inch on the left side and an inch on the right side due to the thickness of the braces which are introduced between the frame and the fairing mounting bracket? Any possibility of detail shots of both sides to see how it affects the fitment of the panels relative to the upper fairing pieces and perhaps left/right bike symmetry when viewed from the top down.
|
From these two pictures below you may see the red circles are smaller than the blue circles, therefore, the red circles are for tighten and blue circled holes are for adjustments. Just rememeber before you put back your fairings you need to loosen the orange circled screws.
I currently do not have the picture from the top of the bike. but I will pot one when I take it next time. is not very noticeable.