Quote:
Originally Posted by DannoXYZ
If starter spins engine, it's working perfectly fine. Other areas to look at:
- power going to ignition coils?
- spark-plugs OK?
- ignition fuse OK?
- power going to ECU?
- power going to injectors?
- power going to petrol-pump?
- EFI fuse OK?
- how much petrol is in tank?
- has ignition-switch ever been replaced?
- MAP-sensor connected?
- crank-sensor connected? positioned-properly away from flywheel?
- TPS-sensor connected? Is it rotated properly? Idle-switch enaged?
Any one of these can cause no-start condition. It's very likely you may have more than one.
|
That was going to be my next question...
If it's cranking/spinning-over properly you need to look at ignition or fuel.
How old is the gas?
Did you check for spark?