ninjette.org - View Single Post - Help with a 1986 Ninja 250 that will not rev up

September 22nd, 2021, 06:06 PM

My manual says 33 pins between the EX mark and IN mark on the cam shafts unless that is wrong. And the marks are level with the edge of the valve cover seating area. #2 cylinder at TDC correct? Should I use the flywheel mark or the screwdriver through the spark plug hole to get TDC?

Thanks
Tom

September 22nd, 2021, 06:06 PM	#75
tomsninja2020 Guest Posts: n/a	My manual says 33 pins between the EX mark and IN mark on the cam shafts unless that is wrong. And the marks are level with the edge of the valve cover seating area. #2 cylinder at TDC correct? Should I use the flywheel mark or the screwdriver through the spark plug hole to get TDC? Thanks Tom