Quote:
Originally Posted by kkim
Kerry,
Is it be possible for one to "tune" that billet piece by drilling the holes out to a bit larger diameters if you didn't mind a little more sound and wanted a little less restriction?  |
Yes absolutely! We have 8 other versions of these for different displacement applications, core diameters, turn down tip diameters, etc.. Primarily the difference is indeed with the outer holes and inner main primary hole. We have others with different degrees of taper. We even have some where leaving the CNC burr(s) around the outer holes (gatlins if you will), helps with the reversion affect. By all means, experiment away! Since you are being somewhat "sponsered" on this project, we can always send you another one if you go too far and/or want to go back to the way it was.
