Quote:
Originally Posted by DannoXYZ
wanna draw diagram of how this would be the case?
Here's how it should be:
|
DannoXYZ if he moves the gray wire from pin 1 over to pin 2 like in the photo where pin 2 was the direct 12v source with key on right ?, ok now where pin 1 should have no volt or ground source load when the key was on right, so if he then left the resistor in same place he there for bypasses the resistor when should have been solider one end of resistor onto pin 2 and other end of the resistor on direct to the gray wire, I'm sure there has to be set min of volt that is need on gray wire for it to function and that 6.9v maybe to low that's my theory.
Maybe neutral or clutch switch
Maybe the side stand
Maybe a bad relay
Maybe a bad pickup coil
He could he could try testing CDI box gray wire see it show the same volt and check the value to be sure that at lease good base on this chart.