ninjette.org - View Single Post - Fork height after tapered roller steering bearings?

Ghostt · June 11th, 2022, 02:51 AM

The only thing I can think of is when you installed the bearing race, it wasn't fully installed/seated, ie not flush with the top of head.

If you didn't drive it all the way down til it bottomed out on the head tube, it would in fact change the height top of the triple tree. The same thing goes for the bottom as well.

June 11th, 2022, 02:51 AM	#3
Ghostt in your machine Name: Scott Location: Summer Shade, Ky. Join Date: Oct 2014 Motorcycle(s): 98 Ninja 250/F12 aka ZX-2R "SERENITY", 91 Ninja 500/A5 aka ZX-5R "Phoenix", 84 Honda GL1200A "SIREN" Posts: A lot. Blog Entries: 25 MOTM - Jun '17, May '16, Mar '15	The only thing I can think of is when you installed the bearing race, it wasn't fully installed/seated, ie not flush with the top of head. If you didn't drive it all the way down til it bottomed out on the head tube, it would in fact change the height top of the triple tree. The same thing goes for the bottom as well. __________________________________________________ *violente et ignorantia* ZX-2R BLOG *Twitter and Instagram = Ghostt_Scott* *I'm not here to change your mind, just to inform.*