Quote:
Originally Posted by DannoXYZ
Hey, that's darn cool!
Super-glue dries hard and may not hold up to vibrations. If it comes off, you'll want to use 2-part epoxy next, the clear stuff that's slightly flexible to absorb vibrations.
Look into Peltier coolers to remove heat from phone. Only catch is they disperse heat on opposite surface, so it'll go into charger. Perhaps make metal heatsink platform above & below charger to draw heat away using Peltier coolers.
|
Ooh poop I misremembered, I did use jb weld to glue the wireless charger to the ram mount (it's been a couple months since I put together this version). Super glue was in the first iterations
Thanks for the tip, looks promising. This is my little part time project. I've got very little experience with electronic engineering n whatnot, so I'm learning as I go!
I'll try peltier coolers + metal heat sink on the next iteration and update with pics.
Right now when its really hot out, I'll rotate the ram Mount to where the wind can flow over my phone, and have the wind air cool it.