[NinjaBraap]

UPDATE!

I bought the ZA pin and the stand. The ZA is supposed to be the 09-16 zx6r, which it definitely is for.

That being said, the engine mount bolt and adapter fits the 05-06 zx6r.

The stabilizer pin is a bit to large of a diameter, and too short, and the lift angle adjustment rod is too short for the angle required for the 05-06.

I'm going to have a new stabilizer pin made, and get a longer lift angle rod, and then it should be gucci.

Will follow up once I have that done, and report whether it was a success. If so, I'll see if it'll work for the 2008-12 and pre-gen 250's as well, and if not what is required to make it work.