View Single Post
Old October 11th, 2019, 12:47 AM   #16
DannoXYZ
ninjette.org certified postwhore
 
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011

Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C

Posts: A lot.
MOTY - 2018, MOTM - Nov '17
Coming along with troubleshooting, good job!

I would save some time and test extreme ends, #1 and #5 clip positions and see which one runs better. Also make sure your needle jet is clear of varnish and not installed backwards. Larger opening should face up towards needle.

One way to pre-sync carbs is to measure gap between throttle butterfly and venturi tube with feeler gauge and set both to be same.

Last futzed with by DannoXYZ; October 11th, 2019 at 02:47 PM.
DannoXYZ is offline   Reply With Quote