So my week went like this:
Tried using a 90 degree offset screwdriver thing to remove stock floatbowl screws. A couple stripped of course a which wasnt really unexpected but it was worth a try as thete really wasnt much to lose. So then pulled out carbs, replaced damn screws with socket head screws, put in the 92 mainjets, replaced some diaphragm screws while I had things apart, and also cleaned out 4k miles of grime out of front sprocket cover area.
I also picked up a set of metric hex driver bits from Ace hardware that fit just like screwdriver bits into my drill bit attachment. Love it!
|