unknown.... but it should... most clutch lever brackets are 7/8" and if your is too it should fit... weather it will clear everything else is the big question though.... not the fit on the handle bar !
give it a try what can it hurt ?
....
to get the handle bar grip off shove a long thin screw driver under the outside edge of the grip all the way to the control housing and squirt WD-40 in there and do that 2 or 3 times... around the rubber grip and then you can twist off the grip....
you can get the WD-40 off with Rubbing alcohol and a rag later.
or you may be able to just split the controls... i dunno.
....
Bob.....
__________________________________________________
Its too late when you've gone too far !
|