Quote:
Originally Posted by Mohawk
If you have these off the bike, can you check something for me please ?
I just stripped checked cleaned my pre-gen ZZR250 carbs, the book says these are 30mm carbs & the outlet is 30mm. But looking at the venturi area, the bore is stepped, so only 28mm at the venturi !
Can you look in the outlet of the 32mm carbs with the butterflies open & see if there is a step on the bore to the venturi area ?
Thanks
|
Ok, I just measured my carbs, they are 32.1mm ID and there is no step, to speak of inside past the butterflies. There is a hairline where the slide area is, on the butterfly side, but I could hardly feel it with a fingernail. Hope this helps!
Charlie
__________________________________________________
God chose what the world thinks foolish to shame the wise,what the world thinks as weak to shame the strong,what is despised in the world,what is nothing,to set aside what is regarded as something
|