ninjette.org - View Single Post

marshallsmith27 · January 3rd, 2022, 02:49 PM

Sorry I didnt make that clear I ran the tip cleaners through every single passage way there was. Lateral and horizontal ones. I bought new vacuum caps just a few minutes ago.

https://i.imgur.com/KDrWLm6.jpg

This is what I have. one carb had almost all the holes and pathways clogged and I think its the one with the super stained float. I checked them they dont let water in when submerged

I have a feeling if I put the carbs on the bike it would run now. I mean I found tons of clogged paths that no amount of the 180 psi compressor I have cleared out �� you were right @Bob KellyIII about the compressor not being enough
@DannoXYZ I did that! I am hopeful now the carbs are squeaky clean

January 3rd, 2022, 02:49 PM	#62
marshallsmith27 ninjette.org member Name: Marshall Location: Tuscaloosa, AL Join Date: Jun 2021 Motorcycle(s): 2007 Ninja 250 and 2006 Triumph America Posts: 171	Sorry I didnt make that clear I ran the tip cleaners through every single passage way there was. Lateral and horizontal ones. I bought new vacuum caps just a few minutes ago. https://i.imgur.com/KDrWLm6.jpg This is what I have. one carb had almost all the holes and pathways clogged and I think its the one with the super stained float. I checked them they dont let water in when submerged I have a feeling if I put the carbs on the bike it would run now. I mean I found tons of clogged paths that no amount of the 180 psi compressor I have cleared out �� you were right @Bob KellyIII about the compressor not being enough @DannoXYZ I did that! I am hopeful now the carbs are squeaky clean