Quote:
Originally Posted by DannoXYZ
That's correct!
Turn ON choke and let it idle fast. THEN turn DOWN idle-speed knob to lower idle-speed to 3k or so.
Then as it warms up, revs increase to 4k. Then turn down choke gradually to idlw at 2.5-3k. Repeat as it warms up until choke is all way off. Adjust warmed-up idle-speed to 1.5k
DO NOT touch idle-speed knob after this. Only use choke to adjust cold idle-speed. It's not all on or off. Last 1/3rd of choke lever can adjust cold idle speed from 3k-5k easily.
|
I got it to idle without a SINGLE PROBLEM for 15 minutes or so, but…. it still doesn’t want to rev. I’m confused because when I started this months back I couldn’t get it to idle but it would rev just fine all day.
I replaced all the vacuum lines and installed the new enricher diaphragm. 110 mains currently and 38 idle. no shims. it’s idling as I type this with absolutely no problem but it will not rev at all.