ninjette.org - View Single Post - Opinions please... 650R Rear Wheel Conversion

DannoXYZ · June 22nd, 2019, 06:34 PM

Finishing up this thread since questions about how to center 650 wheel was never fully answered. Yes, you have to move sprocket in towards wheel by machining sprocket carrier. But this does NOTHING to move wheel itself, only the sprocket.

Second part that needs to be machined is left SPACER. Remove 6.5mm from that and it moves wheel 6.5mm to left to centre in swingarm. Then machine 6.5mm from brake-caliper holder/spacer on right and that's it, you're done! Drawing some pictures really helps with stiff like this. Hand-drawn on napkins is still better than nothing.

June 22nd, 2019, 06:34 PM	#142
DannoXYZ ninjette.org certified postwhore Name: AKA JacRyann Location: Mesa, AZ Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot. MOTY - 2018, MOTM - Nov '17	Finishing up this thread since questions about how to center 650 wheel was never fully answered. Yes, you have to move sprocket in towards wheel by machining sprocket carrier. But this does NOTHING to move wheel itself, only the sprocket. Second part that needs to be machined is left SPACER. Remove 6.5mm from that and it moves wheel 6.5mm to left to centre in swingarm. Then machine 6.5mm from brake-caliper holder/spacer on right and that's it, you're done! Drawing some pictures really helps with stiff like this. Hand-drawn on napkins is still better than nothing.