Thread: '92 rebuild
View Single Post
Old September 4th, 2021, 06:24 AM   #10
BonelessSugar
ninjette.org member
 
Name: Cashby
Location: Maine
Join Date: Sep 2021

Motorcycle(s): EX250-F x 3, TW200, NPS50

Posts: 98
Starter cycles by solenoid so I just jumped it for now.

Left 73psi dry
Left 96psi wet

Right 122psi dry
Right 157psi wet

I used a wet amount of 3/4 tsp oil from here. So they're all low, and range is supposed to be 139-218psi and 125psi to run. This makes me think it's just been running on one cylinder for a while... However, I didn't open throttle at all. For reference, my TW is 122 dry, and its range is 114-149. As a result, I'm not going to subtract 14.7psi for each for ATM because of the output of my TW.

One plug has a screw cap on the top and the other doesn't. Both are Autolite instead of NGK.

Going to trace the harness and rewire so I can get ignition and starter going at the same time and try some starter fluid and see if it can actually start up at all. If it does then great, if not then I'll need to read some more in the wiki or forums and figure out what I need to start with.

Battery is all charged up, 12V 9A. Had to take out some acid I added to equalize all the levels. Going to see if it maintains a charge.

Pumped rear tire from 10psi to 32psi.

Last futzed with by BonelessSugar; September 4th, 2021 at 08:44 AM.
BonelessSugar is offline   Reply With Quote