View Single Post
Old June 19th, 2018, 10:55 AM   #19
Zww1019
ninjette.org member
 
Name: Zak
Location: Ft. Lauderdale
Join Date: Jun 2018

Motorcycle(s): Ninja 250r

Posts: 18
Quote:
Originally Posted by DannoXYZ View Post
Make sure the interlock switches are working.

- kickstand switch: both terminals should have connection when up, 0.L on your meter
- neutral switch: terminal + chassis-ground should have connection, 0.L n your meter

Next is tracing power-circuit to starter-solenoid starting from battery to ignition-switch to run/no-run switch to start-button.


I checked the clutch and kickstand relay switches and they seem fine. So bypassing the starter solenoid relay only helps narrow down the problem? It doesn’t mean that replacing the starter solebiud will fix It? And should I still replace the starter solenoid?

Also I tried following the wiring and still haven’t been able to find anything, the bike is pretty well stripped so I’m able to follow It most of the way. Since the ignition button itself does nothing—no click of noise or anything, like it’s not even there—would this help narrow It down?
Zww1019 is offline   Reply With Quote