Quote:
Originally Posted by NInjaR53
Sorry to bump an old thread, but I'm currently in the middle of a valve adjustment and I seem to be stuck without the special valve tool, I'm on the inside left hand exhaust nut and I cant seem to loosen it at all. It will seem like its loosening and then the socket will lose its grip on the nut.
Do you guys have any tips, I only have the last 3 exhaust valves left and I'm finished but I've been stuck on this one for the past 30 min trying to loosen it
I'm using a 3/8s deep socket and its worked well for all the other nuts so far...
|
sounds like you've rounded off the nut already.
are you using a 6 or 12 pt socket? impact wrench if you have one with a 6 pt socket. plus are you using a 3/8" drive socket or an actual 3/8" socket? If so, why are you not using metric sockets?
btw, you've posted in the pregen section... you have new gen correct?
http://www.ninjette.org/forums/showthread.php?t=67405