ninjette.org - View Single Post

NaughtyusMaximus · July 2nd, 2009, 10:46 AM

So I picked up a 12 inch phillips, and I still managed to mess up the one screw head. I sent a PM to the DIY author who apparently did the same, but perhaps some of the rest of you will have an idea as well?

"Hey, I'm going through your DIY on shimming the carb needles (ty btw!). I managed to strip one of the screws - how difficult was it for you to remove the carbs out, and did you need any special tools to do it?"

July 2nd, 2009, 10:46 AM	#414
NaughtyusMaximus ninjette.org member Name: Jordan Location: Calgary Join Date: May 2009 Motorcycle(s): 2009 ex250 Posts: 98	So I picked up a 12 inch phillips, and I still managed to mess up the one screw head. I sent a PM to the DIY author who apparently did the same, but perhaps some of the rest of you will have an idea as well? "Hey, I'm going through your DIY on shimming the carb needles (ty btw!). I managed to strip one of the screws - how difficult was it for you to remove the carbs out, and did you need any special tools to do it?"