Quote:
Originally Posted by NaughtyusMaximus
So I picked up a 12 inch phillips, and I still managed to mess up the one screw head. I sent a PM to the DIY author who apparently did the same, but perhaps some of the rest of you will have an idea as well?
"Hey, I'm going through your DIY on shimming the carb needles (ty btw!). I managed to strip one of the screws - how difficult was it for you to remove the carbs out, and did you need any special tools to do it?"
|
It's not hard just take your time. Also helps if you have a serice manual on hand. The hardest part for me was getting the air box out of the way. If you run into any other problem we are here to help.