Quote:
Originally Posted by Triple Jim
I tried several methods to get a couple dents out of my tank. The one that worked best was to push them out from the inside. I used a curved steel bar through the filler hole. I had to get creative, welding pieces in and shaping as needed to reach all the places I needed to reach. The tank is pretty thin steel, and is not hard to push out that way. If you go too far, you can put a board on the outside and tap it with a hammer to back up a little. When I got close, I used Bondo to finish it. The Bondo is no thicker than 1/16" in the worst spot.
|
Thank you for the reply! Did you paint the bondo after you put it on the tank? If so could you link what paint you used?