Quote:
Originally Posted by DannoXYZ
Post picture of screw you have, especially close-up of conical tip. Let's see if it's been swapped for incorrect one. As you can see, bleeder screws vary greatly in shape, it's possible someone installed incorrect one on your brakes and that's why it's leaking. Note none of them uses O-ring to seal.
What you saw as "O-ring" is probably remnants of loop holding sealing rubber cap on outside. If you look closely at "O-ring", it has square cross-section, not round?
|
I took a picture of the bleeder screw but somehow it didn't get uploaded to the image site and lost the photo, I'll try and post a pic for anyone that runs across the same issue as me in the future.
When I'm back in my garage tomorrow I'll link a picture.
Sidenote: how do I put an image up so that it shows up directly on the forum thread reply, vs a separate link that opens the picture? I've tried using the image icon button on the advanced reply page but when I used that button I can't see the image on my post