ninjette.org - View Single Post - Ninjette suddenly won't idle/run properly...

KELPHYN · March 31st, 2012, 05:22 PM

Is that one bucket deformed or is it just a reflection?

What actually were your valve clearances?

intake should be no less than 0.0059 in (0.015mm)

and no more than 0.0094 in (0.24mm)

If you have any less than the minimum clearance, adjust. Taking your word you have done it right.

Ideally you would like to be halfway between the minimum and the maximum, around 0.0076 in (0.195mm)

Even if you getting close to the minimum clearance I would adjust them just encase.

March 31st, 2012, 05:22 PM	#17
KELPHYN ninjette.org guru Name: Calvin Location: Quesnel, B.C Join Date: Aug 2009 Motorcycle(s): '08 250R (sold), 2013 300SE Posts: 276	Is that one bucket deformed or is it just a reflection? What actually were your valve clearances? intake should be no less than 0.0059 in (0.015mm) and no more than 0.0094 in (0.24mm) If you have any less than the minimum clearance, adjust. Taking your word you have done it right. Ideally you would like to be halfway between the minimum and the maximum, around 0.0076 in (0.195mm) Even if you getting close to the minimum clearance I would adjust them just encase. Last futzed with by KELPHYN; March 31st, 2012 at 05:40 PM. Reason: adding more