[MikeCL]

Yay valves are done however the idle is still not steady if left alone it will shoot up to around 3k I’m wondering if the cables need to be lubed? If I close the throttle even then I can get it around 1500 but then it slowly creeps up to a little over 2500 rpms.

I think the throttle is binding somewhat it’s not 100% fully returning The high idle with me closing the throttle is the idle screw I backed it off two turns I can get it to idle at 1500 but I have to hold the throttle close just letting it go is enough to send it over 2k

What a nice high of 34 F today ugh

Oh yeah the part that fell into the motor

Wired in diode