Quote:
Originally Posted by exploring/carolina
Using the original temp gauge on the Cafe Racer. Their sender & coupling would be the easy way to go if compatible with the OEM gauge. Will check it out and post coolant hose mods & sender installation getting rid of the thermostat housing while using the Thermo-Bob unit.
|
I would think you should be able to mount the stock sender in a similar inline coupler. In the PDF wiring diagram I have, it shows it as being a two-wire sensor (as opposed to grounding through the mount), so you should be able to stick it in anywhere without worrying about grounding the mounting point. That should give you a TrailTech-like setup with OEM operation.
If it's a single-wire sensor (looks like it in your pic), the worst you should have to do is add a ground wire to the sender housing to complete the circuit.