Quote:
Originally Posted by flitecontrol
If the rust isn't so bad it's loose, you can fix it with Caswell epoxy tank sealer. The rough surface provides a better surface for adhesion. If it is that rusty, just clean it and use the Caswell. Tape over the pinholes before putting the epoxy in the tank. I've used it and it works well. http://www.caswellplating.com/restor...nk-sealer.html |
I thought about that, its pretty bad, I'd like to try and seal it but spending $50 for sealer plus cleaning it out for it not to work sounds scary.
None of the holes are large- 1-2mm in diameter. Thought about filling from outside with tank epoxy then treating inside with sealer (maybe 2 coats?)