Step 6: cut off pin end
Step 7: pull the wire around the notch at the top tightly while holding your finger over the hoop peice to keep it in place.
Step 8: cut about where the X is in the picture you need room for all the pin to be pushed into the groove
Step 9: use needle nose pliers and go round the top of the groove pushing the pin wire in
Step 10: test out your work. If your hoop in the hole is blocking the hole for your spark plug hold the pin in the groove and use a small screw driver to bend the hoop over to the side.
988D5B2A-63CF-4D37-8F53-F6AFFDEB71E0.jpg
2F2327CF-31EA-46C0-AA3F-F3E553230190.jpg
32171BF7-305E-473E-92FE-36A387508CF6.jpg
2D0AA9B4-42E1-4E10-B593-37E7D0554C05.jpg