[Racer x]

After seven months and the conversion from carbs to fuel injection. I am almost ready to start the engine. The engine is a fresh 265cc that I ran last year. I just took it apart and went through the valves and lapped the seats. Rings had some gunk sticking them in there lands. So I cleaned the pistons up and re honed the block.

I changed the hoses the that come with the Ecotrons kit. It took a long time to make up all the hoses. I need a large fuel pump for the nitrous. And I want an adjustable pressure regulator with a gauge. All the lines are stainless steel with 4-AN fittings.

Information is power.
I now have a fuel pressure gauge. Exhaust temp gauges,one on each cylinder,oil temp ,water temp and the O2 sensors. Most of it I can record to look at later.

Looks like tomorrow I will try to start it for the first time.