ninjette.org - View Single Post

DannoXYZ · July 7th, 2019, 04:40 PM

For those wishing to install GSX-R shocks on Ninjette, there is no need to mangle shock by drilling out its upper bushing or your frame with hasty 1/2" drill bits by hand. The 10mm bolt used for GSX-R shock is fine because it generates sufficient friction to hold bushing in between ears.

To use factory unmolested 12mm mounting ears and 10mm shock eyelet, you just need two sleeves like this. Might need to remove 1mm from width to not extend beyond width of mounting ears on frame.

Polaris # 5135275
https://www.ebay.com/itm/302898035590

July 7th, 2019, 04:40 PM	#10
DannoXYZ ninjette.org certified postwhore Name: AKA JacRyann Location: Mesa, AZ Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot. MOTY - 2018, MOTM - Nov '17	For those wishing to install GSX-R shocks on Ninjette, there is no need to mangle shock by drilling out its upper bushing or your frame with hasty 1/2" drill bits by hand. The 10mm bolt used for GSX-R shock is fine because it generates sufficient friction to hold bushing in between ears. To use factory unmolested 12mm mounting ears and 10mm shock eyelet, you just need two sleeves like this. Might need to remove 1mm from width to not extend beyond width of mounting ears on frame. Polaris # 5135275 https://www.ebay.com/itm/302898035590