ninjette.org - View Single Post

diwhiteii · June 22nd, 2011, 03:32 PM

Thanks Greg, I bought the JB Weld STIK Putty. OK, one more question about the throttle bodies what did you do with the vacuum hose on the back of the throttle body. Did you cap it off? Or did you plug it under the tank to the vacuum side of the petcock valve if yours is setup that way? Mine is because it is a 2009 Ninja 250R. The ecotrons EFI kit says to remove the petcock valve that has vacuum and replace it with a simple non-vacuum petcoock or it will not start...

June 22nd, 2011, 03:32 PM	#74
diwhiteii ninjette.org guru Name: David Location: Lafayette, CA Join Date: May 2010 Motorcycle(s): 2009 Ninja 250R, 2013 Ninja 300 Posts: 279	Thanks Greg, I bought the JB Weld STIK Putty. OK, one more question about the throttle bodies what did you do with the vacuum hose on the back of the throttle body. Did you cap it off? Or did you plug it under the tank to the vacuum side of the petcock valve if yours is setup that way? Mine is because it is a 2009 Ninja 250R. The ecotrons EFI kit says to remove the petcock valve that has vacuum and replace it with a simple non-vacuum petcoock or it will not start...