Hey Bill, interesting point. I wound up coming up with a rather elegant solution for this that did not involve any cutting of factory wiring: all I had to do was de-pin one of the ignition wires from a 4-pin connector near the front of the bike and wire in a Y with a 10amp fuse and a relay. Power comes off the 12v acc at the front of the bike and it's only running an LED headlight so everything is great now. I prefer the light coming on with the ignition now, and overall performance seems great. I should have taken photos when I was in there.
If you have details on this other output I would like to check it out. I'm always open to improvement!
__________________________________________________
Don't think, look!
|