Quote:
Originally Posted by jkv45
Check for a vacuum leak around the boots between the carb and head. You can spray some WD-40 or similar fluid around the area and listen for a change in RPMs.
|
Quote:
Originally Posted by Solunatic
Vacuum leak is what immediately came to mind. For that, follow above advice.
I'd take off those carbs and clean them thoroughly again though. I'd probably also get the K&L rebuild kits while you're at it. While the bike isn't THAT old, sitting tends to muck things up. If you have access to some sort of compressed air, blow that through the jets every way possible after manually cleaning.
|
Alright so I should just spray WD-40 on the boots while idle on neutral and see if it acts the same after blipping the throttle?
I'll look into the K&L rebuild kits, thanks.