ninjette.org - View Single Post

trucnh · May 22nd, 2019, 08:27 PM

Dear @gantt,

Thank for your reply.
Yes, i want to read the boost pressure, but before i don't know what is the right position to connect the pipe of gauge, i intended connect it to the plenum. Is it ok for pressure reading of gauge?

About the MAP sensor, yes, Manifold Absolute Pressure, i used a 2.5bar MAP sensor in order to use Power Commander 5 tune based on this sensor data. I also got advice from Jerry Schoenauer from Dynojet about this application. But the question that where is the position to install the sensor, i think about the position after the butterfly of Throttle Body.

Could you please look to the below diagram, advice me more with thank.

May 22nd, 2019, 08:27 PM	#6
trucnh ninjette.org member Name: Truc Location: Vietnam Join Date: May 2019 Motorcycle(s): EX300 Posts: 23	Dear @gantt, Thank for your reply. Yes, i want to read the boost pressure, but before i don't know what is the right position to connect the pipe of gauge, i intended connect it to the plenum. Is it ok for pressure reading of gauge? About the MAP sensor, yes, Manifold Absolute Pressure, i used a 2.5bar MAP sensor in order to use Power Commander 5 tune based on this sensor data. I also got advice from Jerry Schoenauer from Dynojet about this application. But the question that where is the position to install the sensor, i think about the position after the butterfly of Throttle Body. Could you please look to the below diagram, advice me more with thank.