ninjette.org - View Single Post

trucnh · August 8th, 2019, 08:27 PM

Hi Danno,

I'm making the harness, connected DB-37 connector of MSII to the current harness on the bike, but some issues are arise:

01. It is could not cut out the exits Denso ECU and replace completely by MSII ECU because a lot of inputs is connected to this Denso ECU (such as Motor Down Sensor, Starter Switch,...)

02. There are 04 wires for Sub Throttle Valve Actuator, how to treat this actuator by Megasquirt, do you have any advice?

Thanks

August 8th, 2019, 08:27 PM	#31
trucnh ninjette.org member Name: Truc Location: Vietnam Join Date: May 2019 Motorcycle(s): EX300 Posts: 23	Hi Danno, I'm making the harness, connected DB-37 connector of MSII to the current harness on the bike, but some issues are arise: 01. It is could not cut out the exits Denso ECU and replace completely by MSII ECU because a lot of inputs is connected to this Denso ECU (such as Motor Down Sensor, Starter Switch,...) 02. There are 04 wires for Sub Throttle Valve Actuator, how to treat this actuator by Megasquirt, do you have any advice? Thanks Last futzed with by trucnh; August 8th, 2019 at 10:13 PM.