Quote:
Originally Posted by focus101
sup guy i just "tried" to do the needle shimming and i used to, and it was fairly ez to do until i started and was about to go for a test drive, at first i idled and then i hit the throttle it shuts off take it back apart just to check a few things and same thing but now i have it wont rev even at WOT and when im not on the throttle it shuts of.. what can this be im using two washers and a lite smoke cames out the exhaust..
shawn
|
I'd remove the washer until you have it running properly again. They may be the wrong size or sitting wrong, so just remove them. They could be causing the needles to hang-up and allow way too much fuel in - was the smoke black?
Something isn't installed correctly relating to the slides, needles, or diaphragms.