Link to original page on YouTube. Now if your new perch has a clutch switch for detecting wether your clutch is in or out then go ahead and wire it up. If it doesn't like mine then you'll need to jumper the connection if you want to be able to start the bike in gear with the clutch in. Grab a small(22gage or smaller) wire and make this. Then place it into your connector on the bike, press it down flush so its easier to tape up. Now using electrical tape seal it up so it doesn't get wet. When you reattach your horn and high beam switch housing be sure to insert this small nipple into the hole in your handlebar or suffer many frustrating attempts only to fail Now ziptie your taped up connector so its not dangling. Now start the bike and adjust the lever engagement to your preference and you're all done. Hope this help thanks for reading.