Quote:
Originally Posted by DannoXYZ
Yes, it does work because spring-stiffness is based upon number of coils. The more coils you have, the softer the spring (because each coil defects same amount given any load).. By removing some coils, you stiffen the spring. Usually removing 100mm is good amount on these bikes. Then adjust pre-load by using 105mm or 110mm PVC spacer.
|
Whoops, forgot there's already 100mm spacer in fork. So you may not need to shorten spring very much to stiffen it up. Perhaps start with just 50mm chop and make up difference by replacing stock 100mm spacer AND your chopped amount with PVC. So make 150-160mm spacer. Similar to what Maverick's done here: