Thread: Clip ons
View Single Post
Old January 1st, 2020, 01:08 PM   #2
DannoXYZ
ninjette.org certified postwhore
 
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011

Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C

Posts: A lot.
MOTY - 2018, MOTM - Nov '17
I originally used Woodcraft, but they are 2-piece and came with 2" risers that made them higher and heavier than necessary.
So next, I got generic Ali 37mm 1-piece clip-ons: https://www.aliexpress.com/item/32808880316.html

Used this for bars: https://www.ebay.com/itm/192996657715.
Chop into three 10" sections and toss extra into toolbox (I prefer my bars as short as possible for quick response).
Ended up saving about 1.5-lbs over Woodcrafts and about 3.5-lbs over stock bars.

Why don't your bars fit under triple-clamp? Looks like they should fit just fine.
You have to cut fairings in order to fit bars under triple-clamp. Like this:


Or cut little more like this for more lowering of bars. Also cut off fairing-brackets from tank, looks dangerous in crash.
DannoXYZ is offline   Reply With Quote