View Single Post
Old November 20th, 2008, 11:20 PM   #8
TheDuck
Da Duckman
 
TheDuck's Avatar
 
Name: Duckman
Location: Pensacola, FL
Join Date: Nov 2008

Motorcycle(s): '08 250R, '06 Chopper, '80 Puch Magnum II, '01 SV650, '99 CR250/CR500AF Sportbike. '02 CRF450/CR500AF Dirt

Posts: 480
Quote:
Originally Posted by kkim View Post
So, I guess you did this at the same time you did the pods, so you have no before/after impressions to share? how about you pull off the tubes, connect the pods directly to the carbs and see what diff it makes?

thanks for the ideas.
Before: Quiet

After: Noisy... its been so long since I had ridden it at factory specs though, I really don't remenber how it rode before. But it seemed better once I got the jetting *ok* for the HOT SUMMER months with the POD filters but the running at low RPMS seemed little weaker than before. BUT, there were much more obvious changes noticed when I adjusted the mixture screws and added the washers under the needles! Suddenly low RPMs livened up!

When I pull it apart in the future I will try mounting the pods directly to the carbs, but I can assure you, its going to run RICH RICH RICH!
TheDuck is offline   Reply With Quote