been working closely with member dannoxyz on figuring out the exploited ninja's stumbling on top end. frankly it wouldn't pull hard after 11k. naturally i blamed everything else first. i even closed gap on plugs after i had opened them up after stick coil mod.problem is dyno jet and factory pro are giving jet kits that are quite rich. factory pro gives 110,112,115 mains.(tried them all) these are are way to big! to make maximum power, lean mains need to be installed!with danno’s as a guide, the exploited ninja with uni 6”pods is now skirting near stock main jets! i’ve tried 108’s, (moved to notch 3 on needles)102’s,100’s and now heading towards 98’s. keep in mind elevation will factor in too. augusta, ga is 132’ above sea level. exploited finally started to come alive at 102's. 100 mains was even better. it pulled extremely hard on the top end. 98's going in today. 98 mains with pods?wtf? ya i'm freakin but dannoxyz always seems to explain in laymans terms. more to come
