Newgen motor mounts (and the one newgen bolt for the front mount) work great. I ground off the welds for the newgen coils so I can bolt up my pregen coils. Bueno.
The newgen radiator is too wide for the bodywork, so I'll be making a bracket to run the pregen radiator. Not sure if I'm using 1/8" metal (likely steel or aluminum, whatever is available at work) or 3/16" ABS sheet (depending on some research into temp ranges). I have a water jet and light duty laser cutter at my disposal, so I have some flexibility there.
After that, I need chain and sprockets because mine are worn, and I need to figure out if the airbox fits or if I will use pods. Then clean the carbs because they've been sitting so long
