View Single Post
Old October 20th, 2020, 12:35 PM   #15
Turboninjaproject
ninjette.org member
 
Name: Matt
Location: Ontario Canada
Join Date: Feb 2020

Motorcycle(s): Ninja250r frankinbuild

Posts: 33
Thanks for the help

Definitely already annealed the gasket I trimmed the cylinder sizing myself before guy had measurements but wanted to go over factory Bore for simplicity I guess so I asked him to go under bore and I cut the little corners out for the valves myself then annealed with torches had kind of forgot about the valve springs tho I seen another build where the guy didn’t do them and had problems with the head gasket then did and it got worse and made noise in the head wondering has anyone ran stiffer springs on one of these engines And had luck if not I may just stay a lil under factory max rpm I’m sure that’s where all the power is but it runs sooo good and I took so much time to shim it and everything 😂 I don’t really wanna pull the cams again
Turboninjaproject is offline   Reply With Quote