Thread: '92 rebuild
View Single Post
Old September 8th, 2021, 12:45 PM   #28
DannoXYZ
ninjette.org certified postwhore
 
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011

Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C

Posts: A lot.
MOTY - 2018, MOTM - Nov '17
Quote:
Originally Posted by BonelessSugar View Post
I snapped one of the super thin screws holding the clutch sensor onto the clutch handlebar housing (these probably aren't the terms). Need to get a new one anyways because I don't have something to TIG the inside to fill and then drill and tap the hole. If there's another solution I could do (maybe use the steelstik I have for the carb) to fix that? Lemme know your thoughts. Might swap to shorty levers, too, since I don't wanna use this shaved lever.
You can try filling and tapping. What I've done in this case is drill and tap for next size larger thread M6, and slightly enlarge hole in switch.
DannoXYZ is offline   Reply With Quote