ninjette.org - View Single Post - SlingShot Racing Carbon Fiber Parts on my Tricked out Ninja 300

diwhiteii · February 11th, 2013, 11:18 PM

Just what I needed to know! Thanks. Pics? How well did yours turn out? Should I be worried about marring the CF if I sand too much?[/QUOTE]

I will take a picture and post it tomorrow. Mine turned out fine, but because someone backed into my front fender I am going to paint the whole thing so you don't see the spider cracks. I would start with 1000 grit sand paper see how to like it then continue to go down in grit until you like how matte the finish is.

February 11th, 2013, 11:18 PM	#29
diwhiteii ninjette.org guru Name: David Location: Lafayette, CA Join Date: May 2010 Motorcycle(s): 2009 Ninja 250R, 2013 Ninja 300 Posts: 279	Just what I needed to know! Thanks. Pics? How well did yours turn out? Should I be worried about marring the CF if I sand too much?[/QUOTE] I will take a picture and post it tomorrow. Mine turned out fine, but because someone backed into my front fender I am going to paint the whole thing so you don't see the spider cracks. I would start with 1000 grit sand paper see how to like it then continue to go down in grit until you like how matte the finish is.